Ingredients: 2mg/mL Sod. Hyaluronate, a citrate buffer, sorbitol and water.

Directions: Remove the over-cap and turn the bottle over so the dropper tip points down. Prime the system before first use: Place two fingers on the base and your thumb on the shoulder of the bottle. Press firmly on the base and release. Repeat this several times until the first drop is released. Now the bottle is primed and ready for use. Lean your head back slightly and gently pull down your lower eyelid. Press FIRMLY and QUICKLY on the base of the bottle. This enables the bottle to release one single drop into the eye. Release and repeat for the other eye. After each application close your eye slowly to allow the fluid to spread evenly over the eye surface. If you use any other eye drop medication or eye-ointment, please allow at least 30 minutes between applications. If you use other eye drop medications, apply them before applying HYLO. If you use other eye ointments, administer those after applying HYLO. Only use HYLO GEL if the seal of the folding carton is intact. If you use any other eye drop medication or eye ointment, please allow at least 30 minutes between applications. If you use other eye drop medications, apply them before applying HYLO GEL. If you use other eye ointments, administer those after applying HYLO GEL. HYLO GEL should not be used if you are sensitive to any of the ingredients. In very rare cases hypersensitive reactions like burning or excessive tearing have been reported which stopped immediately when the use of HYLO GEL was discontinued.